Search results for query: *

Wow, Access Logix doubles the price of the FC-4700!! My EMC supplier recommends Access Logix tier 5, which is 11000USD, can you explain the tier levels? Are there other tiers that reduce the price? I actually have some LP 8000's, but I am unsure if the card is supported with Sun's multipathing...

Current target system is the FC-4700-1 or FC-4700-2 ( possible earlier systems too eg. FC-5300, depends on the budget ). I plan to run two Sun servers clustered. SAN will be based on 2 SW2800 and each server with 2 QLA2300 each. Is it enough to do LUN masking and Zoning with Switch and HBA?

What I really want to know is; what is the minimum software install for the Clariion DPE for it manage the disks. I am not daunted by using the cli, all of the enviroment that I deal with is UNIX and Cisco IOS. I don't plan to implement powerpath as I will me using Sun Storedge Trafic manager.

I sent a mail to you. WRT access logic, I am only aware of the software license information about using that number of systems. Respond to my email if you want.

When you say cheap, how much do you mean? I have been using DAE's that I have sourced in the USA, I could get a FC 4700 DPE for 5000Euro ( not cheap ), and to configure that with 4TB it would cost well over 10000Euro.

Can anyone describe the FALRE OE to me? I am currently running 10 slot DAE as JBOD, but I am planning to implement a DPE at the end of the summer. Can anyone provide me with a good source of documentation on FLARE and EMC software and the DPE hardware.

Cheers, you were right, the power cable was not connected properly, error is clear now. Thanks

New to Brocade descovered this message at root login; WARNING: envPS002 is below threshold with 0 (1 OK/0 FAULTY) Can anyone explain this warning please?

I have swapped out the fan pack on the rear, for the few seconds that the pack was off, two amber led lit up on the power supplies, but when I reinserted the new fan module the leds went out. The planned configuration for these arrays is HA cluster. Two arrays, data and mirror, two switches and...

I have two Clariion DAE for JBOD use, one of the systems is showing amber "system check" led. It appears to be working I have it directly attached to a Solaris host using two HBAs and two LCC using SC to DB9 MIA. Disks are showing up on only one controller, I swapped the LCC and cables, but the...