My first attempt at a cisco port mirror. basically I have an IPS sensor on port 2 that needs to monitor the internet port on port 1. So I enter the commands to set it up. However, after I do this, my IPS cannot connect to the sensor on port 2.
Basically, I need port 1 and 2 to see each other...
I'm not sure what's going on with this switch, but when it boots up, the management light blinks green for hours which seems like it can't get past post. I've tried to console into the switch but get no response.
Is there a way to reset to factory defaults? What is the default IP address for...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.