Search results for query: *

Ok ran a network settings reset from the menu (never could find an http protocol setting). Suddenly HTTP shows enabled. Web interface is up. Yah. -jh

Ok I just finished replacing everything in rotation only to find that the Laser unit was manufactured slightly off... now I have a printer that has perfect registration and prints great. But. Somehow http (web interface) got disabled. Any ideas? Any ps snippets to restore this? Thanks, jon

Ok, after nearly 2 weeks, a laser unit, a hard drive, and an engine control board.... The cheap freakin company Xerox who charges 1200+ for the laser unit can't seem to manufacture it square. RETARDS. On a last chance hunch I checked the laser unit position again... it was 1/2-1/4 of a mm...

Xerox has the manual available here: https://www.office.xerox.com/partners/products/Phaser560/Phaser560Series.html Directlink: https://www.office.xerox.com/partners/products/Phaser560/P560ServiceManual_PDF/Contents.html -jh

Personally I think maybe a MOB sensor failure, an Engine Board failure, or a Hard Drive (ps file corrupt?)... not really sure which. Maybe I'll order them all and start replacing.... Anybody else seen this?

Hi Cultonflo, Yes I have SB 580v2. I can't seem to get the result to show a block count for either regicon 4 or 1.

Recently I received a Polygon engine failure Error 11 and following the service manual steps I have replaced the laser unit. The error is now fixed. I am currently running into trouble with the RegiCon setup. SM pg 4-118. (SB 580 Rev2) I print the dot grid. Bad alignment. Reset NVRam. Reprint...