Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Print Density Settings
PROBLEMS!!! I have hit a snag in the Dos 6.2 section with Wordstar. I substituted the HPlllp printer with HP Laserjet in Wordstar and as a result found that the pitch available were only TWO viz 10 and 16.67 cpi. I need 12 cpi to print address labels and therefore substituted the Laserjet with... -
Print Density Settings
Dan or is it Chris!!! Am gobsmacked. Why all these [non] pseudonyms? Why not stick to Dan OR Chris. I posted on the HP Community site as Cahoon because I had problems with logging in as Kahawn and the HP site would not accept my accepted logged in details on another HP site. [May have posted... -
Print Density Settings
Thanks for your post Jim Will download and use PrnPrint to post the files that you have compiled. The advantage of using PrnPrint is that one does not have to select the port: In WsWin the port selected is DOT4_001 for the HPLJ1200 while in Dos there is only one port available viz LPT1. [And no... -
Print Density Settings
Reporting... I attempted to post/print the prn files in various ways- Start -> cmd -> COPY/ B pjl_default_density etc and got 'The system cannot find the file specified' Start -> All Programs -> Accessories -> Command Prompt etc and got 'Windows cannot find copy' Then using a utility... -
Print Density Settings
jlasman If you read the thread in HP Business Community forum you will note that I was not ignoring his advice but had problems following the advice with sending the prn files to the printer. However will attempt to send the Density.prn file via the copy / b command again and see what... -
Print Density Settings
Thanks for your reply and advising me why my " copy /b PJL etc" command was ineffective. However I am comfortable with the command within Foxbase as it is only when I am in that Directory [in Dos] that I need to have compressed printing in order to print the financial Reports generated in... -
Print Density Settings
Thanks for your post. I should have entered 'PJL' [not PCL!] However I have two prn files written for me [on HP Community forum] that I downloaded to my computer but was unable to 'post' them to my printer and then went down the route of writing a routine within Foxbase+ with SET PRINTER ON... -
Print Density Settings
I have acquired a HP LaserJet 1200 series printer and am attempting to set the factory print setting of 3 to 5. HP have given their PCL codes to achieve this and I have had a 'program' .prn file written for this but am unable to send it to the printer. I have however written a routine in...
