Search results for query: *

OK, I thought so. I was confuse when it talks about using MAC-LIST, wasn't sure how that worked.

Can I have a ACL that can permit or deny access from a device coming from the outside by its MAC-Address to a server in my internal network?

The reason why I say that is that inside the pix, i can ping 205.143.139.34. From the outside(from my home for example), i can't ping it. I did a debug icmp trace and I see the icmp request from my house coming in through the pix. I don't see any reply from the server. If I clear xlate...

I'm sorry, I must of not copy over the static rules. I have the following static static (Vlan5,outside) 205.143.139.0 205.143.139.0 netmask 255.255.255.192 0 0 Vlan5 is our DMZ. These servers are in the DMZ. Also 205.143.139.34 is also our secondary DNS as also being use as an student Web site.

Here is the config : Saved : Written by enable_15 at 09:05:10.437 UTC Thu Oct 2 2008 PIX Version 6.3(5) interface ethernet0 100full interface ethernet1 auto interface ethernet2 auto interface ethernet3 auto shutdown interface ethernet4 auto shutdown interface ethernet5 100full nameif ethernet0...

I have a PIX 525 and we have an internal web server that external users can not get to. From the inside everything works fine. If we do a clear xlate, it starts to work again from the outside but it doesn't last for much. We have to do another clear xlate. Is there a problem with the PIX or...

Got it working! Thanks

It has CatOS. And yes there is a ip address with a route

I looked at the switch and telnet is enable.

Ok, what about the no pinging?

I have a Cisco 6006 that I can't telnet or ping to it. Yet the switch is up and running. I have three other switches running off it. I can ping the other switches. If I telnet into one of them and telnet from it into the 6006, i get "Password required, but none set". I can ping to it also. Any...

Still have the problem, any ideas!!

Have three computers that take for ever to obtain a ip on PXE. If connect a hub on the switch, I get a ip in seconds. we have a 6509, vlan interface is configured for ip address helper, no directed-broadcast. Any ideas?

That was it. Thanks a lot

Not sure what happen but I used to be able to ssh into the PIX. I have the entry ssh ip outside and inside I get a "server unexpectedly, closed network connection" We had a outage and when the PIX came back, I was not able to ssh into it any more. Telnet works fine.

Yes

I got it working, it turn out to be a server issue. I do however have a problem where I will lose connection on the ssh, by doing a clear xlate, it comes back. I have to do this onces a week. Is this normal?

I'll get back on this later, my configuration is over 300 lines.

The gateway and submask are correct. I can see the world also. The PIX has to much sensitive data, I'm not aloud to give it out.

Also, we have a outside router, from there I can ping the one server that works likes call it serverA, but I can't ping the other server (serverB). Again, they are on the same subnet. There is a route on the outside router via the inside interface that goes to the PIX. (ip.0/26)