Search results for query: *

Wondering if any one has used a MPLS circuit on the BCM. How was it configured (through cisco router?) or why it won't work. Please help! Thanks!

a couple of things you can do: 1. Try powering down both the ksu and nam then bring up the ksu first once it is back on line then bring up the nam. If that doesn't work power the nam down and remove the mother board (with a ground strap) and gently take an eraser like on a pencil to the edge...

The whip is tailed different on a BCM then the one from the MICS... even if you were to use a DSM 32 it still has different pinouts comming from the amphenols. Just start fresh.

DCH 3 UIPE_IMSG CC_SETUPCOMP_IND REF 00005F9B CH 1 1 TOD 13:44:30 DCH 3 UIPE_IMSG CC_SETUP_IND REF 00002E0F CH 1 2 TOD 13:44:54 CALLED #:8700 NUM PLAN: UNKNOWN DCH 3 UIPE_IMSG CC_SETUPCOMP_IND REF 00002E0F CH 1 2 TOD 13:44:58 TIM000 13:45 27/2/2006 CPU 0 DCH 3 UIPE_IMSG CC_DISC_IND...

No... it says unknown

Service provider has been contacted and they are sending the Name (they setup a DCH Trap) the problem must lie in the switch, and I wonder if it has something to do with the disabled serv in 96 but when I try and change it with ENL SERV 3 it does not change the status. Thanks!

ADAN DCH 44 -- Mine is 3 CTYP MSDL--- Mine is TMDI GRP 1 DNUM 12 PORT 0 DES MAIN-NUMBER-PRI USR PRI DCHL 35 ---- Mine is 1 OTBF 127--- Mine is 32 PARM RS422 DTE --- Mine is RS232 DRAT 64KC CLOK EXT IFC NI2 ISDN_MCNT 300 CLID OPT0 CO_TYPE ATT-...

Tried to enable serv 3... it still comes up as disabled. Do I have to disable the DCH to make changes to it?

The stat serv is dsbl- should I chng it to enable and if so how do I do that? And RCAP is COLP- I don't even see that option listed in the NTPs. Thank you so much for responding!

Still no Caller name on display, Enl and MSGI X where it says NUM: it is almost always unknown. The generic software is 2111 and the release is 24.24- not sure if system allows this function at all? is it only on higher release? Anyone have another idea about what might be going on?

How do I know what the DNUM has been programmed as?

Opt. 11 TMDI card (NTDK78AA Rel. 11) no name displays on phones just number on their PRI... checked with service provider and they say it should be coming across? Thanks!

I realize I can print out the phones and count up each model, but looking for quick way to just get the total 2616s or 3904s, etc. Thanks!