Search results for query: *

It strictly occurs when making outbound calls across our local PRI to toll free and local numbers where the receiving carrier sends the answer supervision protocol back to the Fujitsu. Thanks...

I deleted the trunk and readded it as 5ESS and then added the B-channels. The only parameter I specified was the Slave on the D-channel and the DID-all on the B-channels. All other paramters I left blank. I saved the config and rebooted the switch. Now when I try and make a call it says "DENIED"...

Thanks again ksphoneman. If the 9600 setup as DMS100 generally ignores commands it cannot interpret, any idea what else to look into? If DMS is more forgiving than 5ess, then wouldn't switching it to 5ess likely cause me more problems? Is there a timing parameter that can possibly be increased...

I'm at a loss folks. I am contemplating deleting the trunk group 139 which is 00001600 and set to NT DMS100 and then readding it as 5ESS. Do I have to delete trunk group 131 which is all the B-channels starting at 00001601? Also, is there anything I need to lookout for when doing so? If I get...

Thanks ksphoneman. Both SVP 2 and 69 show data 0 The iscbc is showing "none". Here is some more insight. My former carrier supplied to local PRIs, both configured as Ni1 Custom 5eSS as the switch type. The 9600 has always been configured as DMS100 as the switch type for the trunk groups and it...

I'm having an issue after switching to a new local PRI carrier. Used to be with AT&T and now I'm having issues dialing numbers respog'd to AT&T. Did some testing and the Fujitsu 9600 is disconnecting when the remote carrier sends an "answer supervision" code back to the PBX usually when the call...