Search results for query: *

We use this heaps at my work. As long as both phones have VOUA and VOLA you shouldnt have too many problems. As long as the networking is setup correctly.

Our company uses AUT codes created in LD88 to allow staff to dial IDD. Is it possible to administer these codes from within OTM 2.2? I am unable to find anything in the OTM manual that describes this which may mean its not possible. Anyone know how to do this?

Where I work we also use these codes to allow IDD dialling access. We do all of this in LD88 though so maybe you already know the below commands. To view LD 88 REQ prt TYPE aut CUST 0 SPWD CODE 2 AUTH005 CODE XXXX <- 4 digit code LD 88 REQ new TYPE aut CUST 0 SPWD CODE XXXX <- Code SARC...

Some of the phones I have wont boot to this screen and even if they do some of them are unable to be confirgured correctly for my VOIP network, they ask for every DHCP option even though they are set to auto DHCP for exmaple. Hence why i want to revert it back to factory defaults and start again.

Sorry, I should have been more specific! I did mean restting the software on the phone to defaults. Basically there are a few phones here not booting correctly or are stuck in a config loop and I was hoping to reset them to defaults and start again, rather than send them back to our vendor. I...

Hi all, I am wondering if it is possible to "hard reset" these phones to factory defaults? I cant find this information anywhere but find it hard to believe its not possible. I have opened one up and cant fine a battery, jumpers etc etc. Any ideas?