Search results for query: *

[thumbsup] to lopes1211

Thanks to everyone that took the time to respond...renews my faith in mankind.

It would appear that lopes1211 gets the prize on this one, I changed the "slave" PBX to sync off the ds1 connected to the "host" PBX, and I just had my first 15 minute time slice on "list measure ds1" without any CSS/ES counts....all zeros on both ends. Thanks CL

davidpayne- I did turn off the echo cancellation, still getting the 12-13 slips every 15 mins on both ends. Will try playing with the cable, see if I can find one that has shielded pairs. I wondering how to connect the two with a network-type cable (RJ45 ends)without the CSUs (120Ax) ??

davidpayne...I do have both ends plugged into 120Ax on both ends, I know I don't have to for such a short distance, but I don't have any other way(no amphenol cables). phoneguy...I do have CSS counts on both ends (identical), but only have ES counts on the G3 end, which is the "network" end...

I had the DS1s set that way when I first configured it, and I was getting the exact same errors/counts. I changed it yesterday after reading several postings on this site to see if it changed anything, and so far it hasn't. I've read every posting I could find about slips/errored seconds/etc...

I'm using a 568B cable, so on one end pins 1&2 are white/orange-orange/white, and pins 4&5 are blue/white-white/blue. On the far end I have pins 1&2 as blue/white-white/blue, and 4&5 are white/orange-orange/white. The circuit comes right up when I plug in, and the everything is in-service/idle...

The cable is about 10 feet long, I can make another and give that a try. I cut the ends off a standard CAT5 network cable, that's what I'm using now.

Here's the DS1 configs... Here's the S8400: DS1 CIRCUIT PACK Location: 01A03 Name: Tie to PBX Bit Rate: 1.544 Line Coding: b8zs Line Compensation: 1 Framing Mode: esf...

I have two PBXs cabled together with a T1 crossover cable, one is a G3siV6, and the other is a S8400 with CM 5.2. Both systems have TN4464F circuit paks in them, and the link between them is configured as an ISDN-PRI trunk. When I do a "list measurements" on the G3 DS1, this is what I see...

We do transfers to voicemail(#0) all the time on bridged appearances. You need to have at least 2 buttons bridged in order for the transfer to take place, otherwise there won't be a line to complete the transfer. SB

We couldn't get it to work either, ended up using the Immediate Divert (iDivert). Requires pushing a button, but the execs didn't seem to mind.