Search results for query: *

2 ways to set up. 1: Make shore the fiery has Direct, Print, Hold Queues on and then look up the fiery on the network and pick the queue you want to use and when it asks you for the driver load the latest form xerox.com. 2: Install the driver using LPR port not Standard TCP/IP port and for the...

Problem 1: When powering off/on or coming out of power save the machine will check the line, if the reply does not come back quickly machine will display no communication on this line but if you cancel the message the fax still works. Timing cannot be changed, this is not a fault it just a...

If you run the white stripes test upto 10 times can have the same correction has printing 10 copies of one colour. The heads do get clogged and also get other colours on them (eg yellow becomes orange). Doing the white stripes test is the best way to clean all heads in one go, you just need to...

This code is to do with ROS assmy. Which is the laser unit. there is a sensor in the ROS that checks the laser on timing and it is saying that the scan time is to long. 80% shore that you need a need ROS assmyP/N:062K09722. It may also be the MCU PWB but try ROS first.

Moisture may be the problem. To test this print your test page then put it in the tray and print on the other side of the page, if it is moisture the 2nd side should have no toner lifting as the fuser will dry the paper the first time through. The fix for this is to dry the paper before use. If...

When the machine starts showing that the maintenance kit needs replacing it starts with about 20% life left to give you time to get a new one. The kit only contains One feed kit. You could just get a feed kit for tray 2 to see if the this fixes the jamming problem.

This seems to be a separator problem. I would be checking the sep pad/roller if you do a lot of 2 siding from this tray they get very dirty fast and need cleaning/replacement more often. Humidity and static do cause problems but I would think you would have the same problem in tray one if this...

There is a Xerox dealer on the Coast, cannot remember the address. Has been 3 years since I have talked to anyone from there. They use to have a few tech's that were very good on C410's. I was on the Goldcoast in April but only on holiday. I hope one of the two tips I gave you helps, I have...

The ADC sensor sits under IBT belt. (when you remove the drum it the big flat belt you can see) You can see the sensor inside down to the left. if you are carefull you can clean it with a soft cloth but becarefull of static because this sensor can be damage by it. ( You are meant to take the IBT...

Which ports are you using? Direct: prints directly to the DC1250. Print: uses the fiery to spool the job and keep in printed queue. Hold: Holds it in the spool queue for you to rip and print when you are ready. Direct is the fastest way to print.

U8-2 is a Low Density failure code. There is a sensor called an ADC sensor that measures colour patches for density of colour. This sensor may be dirty/faulty. But I have some machines with this fault that have problems with faulty toner. Or the dispense motor is not working. There are more...