I have two switches, one a 3COM SuperStack II 3300 and a LinkSwitch 1000 that I set up ip addresses for through the console, but I can not browse to them. I searched the forum, but found one person with the same issue, but noone ever responded.
I'm hoping someone else may have had the same...
Well, the answer to this one was actually simple. I reset the switch and tried again successfully.
I found an article that said to use hyperterminal, but only set 9600, 8, 1, NONE, NONE - FLOW CONTROL and NOTHING else.
This didn't work until I reset the switch.
I can not connect to the LinkSwitch 1000 using a null modem cable so I can set an IP address on it. I used both 3COMs WEB SLIP Utility and hyperterminal. I set both to use VT100 emulation, 8, 1, N, 9600, COM1.
I have been successful connecting to my three Superstack II 3300 switches.
When I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.