Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. JimAntonic

    Origin 200 and QLA2200

    you need IRIX 6.5.19 or higher
  2. JimAntonic

    New to Irix lost need to find my way

    try logging in as "root"... this is the super-user/admin log-in... you may have to reset the password to use this system
  3. JimAntonic

    PCI-X Copper Gigabit Ethernet card

    Does anyone know if there is a non-SGI copper gigE that will work in an SGI machine? I was thinking I could get one from 3com and save some $$$. Thanks.
  4. JimAntonic

    LED 4B27D410

    translated that chinese post... all i could get is some gibberish about the CPU, so i replaced it... works like a champ now... this was an RS/6000 7044-170
  5. JimAntonic

    LED 4B27D410

    My system is hanging on LED 4B27D410 during start-up. Can anyone tell me what it means? Thanks for your help.
  6. JimAntonic

    Irix install killing me!!!

    are you using the right disk? the installation tools are on Overlays 1 of 4
  7. JimAntonic

    where is my CDE?

    I just loaded my system with AIX 5.2 and the system came directly up to the diagnostic menu in the maintenance shell. I can get into a GUI by typing "xinit" in single user mode, but i want to be able to use the CDE. Does anyone know how to get into the CDE? i also want to make sure that it...
  8. JimAntonic

    RS6000 model 150 stalls on 0549

    so does anyone know how to configure the console?
  9. JimAntonic

    RS6000 model 150 stalls on 0549

    I have a system here that does not boot up. After i get to the "starting software" message, my screen goes blank and the operator display stalls on 0549. Not getting output through the serial port either. Anyone know how to fix this? Thank you in advance for your help.
  10. JimAntonic

    RS/6000 Model 150 displays ??? as CPU speed

    anyone know why this happens? i'm not getting any error messages. if i use the pmcycles command it clocks the correct CPU speed, but the prtconf command gives me the following output: /usr/sbin/prtconf[81]: (procspeed%1000000) >= 500000: bad number any help would be greatly appreciated! thanks!
  11. JimAntonic

    O2 Boot Problem

    sounds like a memory problem... probably just needs to be replaced, but it could be installed improperly (loose or in the wrong slots). also, your o2 should work with most non-SGI keyboards and monitors.

Part and Inventory Search

Back
Top