Recent content by zakman99

Sorry I should explain a bit more -- Switch is 1000M Rls. 7.5 Received new phones that have a higher FW than was on the switch which forced them to go into a reboot cycle. Added new FW to SS via EM Ideally I'd prefer to to schedule upgrade of FW the same way I can to TDM sets. THANKS!!!!

I'm having trouble with the syntax of pushing out firmware to 1140/1150 phones. Anyone have an example or a tip? Thanks in advance!!!!!!!!!!!!!!!!

I'm trying to find the General Greeting and Dial By Name mailboxes and am not having any luck. Any suggestions are greatly appreciated! Thank you!!!!

DOH!! Thanks!!

How do I get the status of teh Media Gateways via Gedi? Thanks!!

You are also double sending NXX -- CALLING# COMP: 6308568564909 check your ESA and CLID entries

It looks like the Crisco is conf. the call into the M1 via the OSN data TER RTMB: 41-131 ACOD: 8789 TER RTMB: 41-128 ACOD: 8789 Can you post the OMSG as well. Thanks!! Jack

It looks like the Crisco is conf. the call into the M1

Have you tried to reseat the MMDU?

Could you post the D-Ch messages?

I received a request to install one of these and having looked thru the manuals I have a question or two. The site that this is at is an SRG50 where they use i2004P2 phones. My first question is can I use the the Ethernet port on the back of the 2004 to hook this beast up or do I need a...

While I understand how to set the automatic DST feature and how to get the switch to look at an NTP server, I've noticed that my Sig. Servers -- using the date command -- do not update automatically. Any ideas on; why this happens and how to get this resolved? TIA ZAK

Just curious, is there already an SEB type device on these systems that you could use for remote access?

Folks, Is there any other Timer other than the RDB TFD that could disconnect a call after approximately one hour? Thank you in advance!! ZAK

Force down load the 3900"s