Recent content by wutt

Do you have the printer installation cd? If so try installing from that if not download it from the manufacturer (if possible) and try that. I've seen many units that have a hang up with printer drivers but instal great from the cd, floppy or download. Good Luck wutt

I have an XP unit on a public library network that reverts to previous boot on reboot. Can I change this setting? I noticed this when I changed IP addresses and added a folder to the desktop and rebooted. The IP changed back and the folder was gone. I made sure I saved the IP configuration and...

Further info I tried putting a new desktop folder on the desktop and when I rebooted it was gone. I feel that any changes being done are not permanently saved and everything reverts back on reboot. Is there a setting on this I can change to allow for changes? ps. i did an ipconfig/all and it...

You know what you're dealing with! gates foundation is active on the win2k's but I'm not sure about the xp units. But why are the other two xp's and all three win2k units Ok with the changes? Thanks Wutt

I did an IP config on it. I will be back at the Library where this unit is this afternoon and will try IPconfig/all. and reply Thanks!

When I change the IP (and an imbedded IP in an application .ini file) It communicates fine with the network. When I reboot both IP addresses are changed back to what they were before. The old IP is out of the routers range so no network communication happens. Thanks! Keith

I changed the IP addresses on 3 XP units to accomadate new router IP range. 2 of them are fine the third reverts to its old Ip on reboot, even after using the 'repair connection' feature. Any ideas? Thanks Wutt