Recent content by wallot

Hey lopes1211. The real question is, why I can't install 10.2.0.1.1 or 10.2.1.0 on the CMB. Both state they can be installed on GA 10.2.0.0. I need CM2 to be at the same patch level as CM1 which is 10.2.0.1.1. And, the patches once uploaded via the SMI, don't show up when selecting Manage...

Good day! This is fairly new to most of us, the new ASP130 R6 that uses RHEL with KVM as the hypervisor, replacing VMware ESXi. I have successfully deployed CM 10.2.0.0 on ASP130 R6. My duplication link is up, pending updates. (CM1 is on ESXi). Updates are in the /var/home/ftp/pub folder. 1...

Good day I'm loading a new CM 10.2 VM on ASP130 my first time and I don't have the reset system 4 and no change command in CM. Something new with 10.2 perhaps? Thanks!

Morning! Trying to recall the CLI command to show the ASBCE configuration. Does anyone know? (Currently, GUI is network blocked....) Thanks!

Setup Configuration for SCC SCAP Scans in Avaya Communication Manager - Create RHEL user (not CM) like scap or scan - useradd <user name> - set password for new user = passwd <user name> - in CM CLI, su - root - enter root password - vi /etc/ecs.conf * Without the next 2 lines, the sshd_config...

The solution is to add a RHEL user rather than a CM user with useradd. Thanks!

Thanks everyone. In the end the 3rd one Avaya sent was a charm. There was definitely something wrong with them.

Thanks, we have 78 G450s/G430s up and haven't had any issues. The only difference is these 2 we have been banging on were DOA replacements refurbed from Avaya. All the rest were new out of the box. You don't load new firmware on the active boot bank. Of course, we copied the serial number out...

Good day folks We have received 2 G450s from Avaya - "refurbed". We are unable to get either to register with CM and have requested another. We took one of our project spares and it came up with no issues and on the same network port. Is there something that does not get cleared on a nvram...

Thanks, After all the years, they have not added that feature in the scan tools. We'll keep looking.

Thanks, I know where it comes from but for the DoD, we have to disable or remove it so the scan tools can login. It's been a while since I worked this area and I know there's a way to remove it but have lost that knowledge :)

Need to remove this prompt "Enter your terminal type (i.e., xterm, vt100, etc.) [vt100]=>

Morning folks When logging into CM 10.1.3.1 via the CLI, the system is prompting for a terminal selection type. We need to remove that prompt because the security scanning software cannot defeat the prompt causing a login failure. Seems like I knew the answer to this but haven't had the issue...

Good morning folks I'm stumped here. AURA 10.1.3.1 Short = when I add a Session Manager to System Manager, both the entity and management, the Session Manager is not getting the SM100 config data from System Manager. The SM is getting trust and DRS successfully from System Manager. The SM...

Good day folks. I'm looking at a system that has entity links between 2 SMs - this system is 10.1. I know the options on what SMs that can be assigned to a SIP user has changed. My entity link is between SM1 and SM3. This may be something that is new to AURA 10.1 but just trying to see the...