Recent content by TioDu62

Yes, a member of Hunt Group can have a call list in place. There is no restriction. Direct calls to this member will be diverted if call list is active.

I did not understand your question.

But it does not point an Action to correct the fault.

I have been browsing the CPI for Provisioning Manager´s fault location and it said that this case is most probably a "network problem".

Have you tried with others Profiles? Try to restart the Webserver in mxone_maintanance in webmanagement, than choose option G.

What is the Provisioning Manager profile being used? Profile like System Setup Admin, can´t create extensions.

Does the fault ocuur only when trying to create an extension?

The PM/SNM SOAP interface is being stepwise replaced by the new Rest APIs in the modernized PM/SNM. The old PM/SNM SOAP interface will be removed once the REST APIs in PM/SNM are fully implemented, for all operations.

Is the PM running the same version of your MX-one system? I mean 7.8 SP0.

Hi Is your PM installed on a stand alone machine or in one of the system servers? Are you sure the authentication is correct? By defualt PM uses port 80 and https. When authentication is OK, you must see the screen as the attached file with the correct type of LICENSE, in my case I am using...

Here is the commands to be used to update the board FW First you have to upload the firmware file CAA1580054_R5A.bin (see attached) to the /tmp directory of LIM 1, use winscp to do it, the file must be transfered as a binary adjust winscp correctly to avoid data corruption. Once the file is...

What is the current FW of your TLU83 board? Verify with the command board_sw -status -bpos (board position of your TLU83) I can upload the latest FW and instruction on how to update the board.

What value you have for VARC D4 of your route? If you are using TLP11, VARC D4 must have the values: 1 for CLI DTMF 3 for FSK ETSI Standard 5 for FSK BELLCORE Standard Both FSK and DTMF are not accpted on the same route.

IOSII:IODEV=SYSDISK1,NODE=SYSN,BTYPE=ATA,SUBFS=SYSSUBFS11&SYSSUBFS21; This command works for NIU2, if you have NIU1 the BTYPE parameter is diferent, Verify with IODDP.

Does anyone know where to find a SIP provider that make available a SIP trunk for testing.