Recent content by Tinos

@DoubleDizzle that resolved the issue. Thank you and consider this thread closed.

Thank you for your response. System start port and and number of trunk ports is already done and was working Clicking drop down arrow to select SIP is greyed out as in the picture and wont change. IP Trunk licenses are active. Which one is Feature Activation?

Hi all. I have a configured SIP Trunk which worked fine and has suddenly stopped. Incoming calls fail and provider receives 486 Busy from NEC for all INVITEs. Outgoing calls fail with a busy tone. When I check 14-18-01 System Data > IP Trunk Data Setup > IP Trunk Type is set to "none". Initially...

Good day. Just checking once more if anyone has had this issue and managed to resolve to advise.

Good day all. I would like to understand the selection of Carrier Choices in program 10-29-14 : SIP Server Information Setup - SIP Carrier Choice (Carrier A) How do you know which one to select and what are their impact?

I have removed battery for 5hrs, put in a new one and went through the SD card steps again. Sadly both RUN and ALM are continuously lit and recovery did not occur. I am inviting more ideas to try.

The dealer has expressed that licenses wont be moved to the replacement CPU. I have to repurchase licenses for the replacement CPU. Eventually I will do that however I would like another shot at recovering the "bricked" CPU. Has anyone else experienced this and worked around it?

I wont replace the SL2100 as this was an unplanned incident when there is no budget for a rip and change. I did flash again and left it overnight, still LEDs not flashing. Definitely bricked.

When I buy a new CPU to replace what happens to the licenses on the bricked CPU? Do they get moved to the new CPU by partner?

For the SD card procedure, RUN and ALM LEDs do not flash 7+mins after releasing LOAD button when powered on with LOAD button pressed. I take it this is a sign of a bricked CPU which needs to be replaced or there is yet another way to recover?

Unfortunately WebPro does not open. Last known IP address or 192.168.0.10 is not reachable. Please share the procedure for using SD card. System is long past warranty.

Good day. I have SL2100 which I updated the software to v5.30. After the system reboot all phones gave no dial tone and digital phones have blank screens. Factory reset also does not fix this issue. How do I recover the system to start working again?

To conclude please clarify which ports goes were using the below codes: No VOIPDB card installed. 10-12-01 IP Address = 0.0.0.0 10-12-09 VOIP IP Address = 192.168.1.2 84-26-01 VOIPDB DSP IP Address = 192.168.1.3 Port 5060 forward to 192.168.1.2 Ports 10020-10083 forward to 192.168.1.3 Is the...

I removed powered and powered the SL again and Start button is now active.

Please add some notes to your response. I am failing to follow.