Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations John Tel on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by TCChenDH
-
Point to Point Speed issue
OK here is my "show interface". Am I just assumming that my connectin should be better? Is this a good T1? Ethernet0/0 is up, line protocol is up Hardware is AmdP2, address is 0005.32b5.0c20 (bia 0005.32b5.0c20)... -
Point to Point Speed issue
OK, I ran a few more telnet sessions and below is what i got. My question is .... What speed should I be getting? Is copying a 30MB file in 8 minutes normal or slow? This is my first point to point and not sure what to expect. Ethernet0/0 is up, line protocol is up... -
Point to Point Speed issue
KiscoKid, I did what you said and here are my results: What do you make of this. anyone else that would like to jump in please do. Ethernet0/0 is up, line protocol is up Hardware is AmdP2, address is 0005.32b5.0c20 (bia 0005.32b5.0c20)... -
Point to Point Speed issue
FYI - Here is my config... Please help MAIN SITE Router#show running-config Building configuration... Current configuration : 564 bytes ! version 12.2 service timestamps debug uptime... -
Point to Point Speed issue
I have setup a Point to Point with two Cisco 2610's with T1DSU WIC's. Everything is up and functioning, however the speed is not what I was expecting\promised. When I call the P2P provider they say "the pipe is clean". I have read many posts and seem to think my config on the routers are...
