Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by stayconnected

  1. stayconnected

    How to reliably configure a secondary failover route for Layer 3 Cisco Switch?

    Is it possible to upgrade the license feature on these older 3750 Cisco switches (not the newer variety which have the license commands) by simply upgrading IP Base to IP Services by simply uploading the IP Services image and nothing more?
  2. stayconnected

    How to reliably configure a secondary failover route for Layer 3 Cisco Switch?

    OK seeing as I've had no further response I think I'm best to upgrade the software from IP Base to IP Services allowing me to using IP SLA (otherwise it's dynamic routing and NO other alternative).
  3. stayconnected

    How to reliably configure a secondary failover route for Layer 3 Cisco Switch?

    This is my version (it's a stack of three switches) Switch Ports Model SW Version SW Image ------ ----- ----- ---------- ---------- 1 26 WS-C3750-24TS 12.2(50)SE2 C3750-IPBASEK9-M *...
  4. stayconnected

    How to reliably configure a secondary failover route for Layer 3 Cisco Switch?

    Can I use the track command if IP SLA is not supported? Looks like the Cisco 3750 does not support IP SLA - apparently this can be checked by running command #sho ip sla application - and if the command does not work then IP SLA is not supported :(
  5. stayconnected

    How to reliably configure a secondary failover route for Layer 3 Cisco Switch?

    The admin distance routing method would be better rather than engaging RIP or OSPF for dynamic routing. Firstly, was I right in thinking that just programming in an admin distance of 200 will not necessarily work reliably - this is just something I have heard second hand, but perhaps would like...
  6. stayconnected

    How to reliably configure a secondary failover route for Layer 3 Cisco Switch?

    I would like to configure a secondary route for a L3 Cisco Switch, in this case a Cisco 3750. The primary route goes via a Microwave link, but when or if the Microwave link should fail I would like to route via a VPN connection. Current configuration on switch for the primary route is: ip route...

Part and Inventory Search

Back
Top