Recent content by ShikePoke

I need to change the dns/ntp info in a One-X server...but having trouble finding the doc's that reference this. Any help out there?

Disregard, got it.

Trying to find doc's on CM3 online, not much to be had. I'm adding an S8300/G700 lsp onto an S8710 CM3.1.4 network. The second page of the "ch surv xxx" looks like: Proc Interface Destination Session Chan Enable Appl. Mode Link/Chan Node...

FYI, I found it. The phone must be authenticated and registered before you can view the settings again. mute (vpnmod) worked. Thanks anyway!

Does anyone know the mute command for entering the vpn settings of a 46xx phone after it has already authenticated? I've tried mute (VPN) and mute (VPNMOD). I need to view the Phase 1 and Phase 2 settings again...I entered them manually and now need to set up my .txt file. Thanks.

OK, took it back to 3.2.57, loaded config, then upgraded striaght to 5.0.22. All resolved, thanks all. Shike

Now can I load the .cfg file that I have at 3.2.57? Or must I downgrade, load the .cfg, then upgrade?

I loaded manager, and used DTE maintenance for this procedure(I'm moving forward finally!): Procedure: Erasing the Core Software via Debug 1. Run Manager. In the BOOTP entries, check that there is an entry that matches the MAC Address, IP Address and .bin file used by the system (the first two...

Yes, tried "password", still fails immediately. Just downloaded latest 4.2, fully installed manager, will let you know. thanks, Shike

I tried to go straight to 5.0.22, it failed immediately. I'm now downloading 4.2 manager to see if it will recognize those .bin files.

This is the directory for both: C:\Program Files\Avaya\IP Office\Manager\V3_2_999 Still nothing on the upgrade wizard.

Ip office 412 at 3.2.57 having issues with 5.0.22 manager seeing the bin files for 3.2.999, 4.2, any others. This should be a step upgrade process, but the only .bin files manager recognizes is the ones in the default directory for 5.0.22. Thanks, Shike

Thanks both. I do have tenant partitions, so routing to "attd" would not work for all of them (there are 4). I'll review the document...thanks for the heads up. Ben

I have a user that swears that the a, b, c, d buttons would beep and blink for additional calls to the console attendant. I recently re-installed a G3si V11 for them and now the "Individual Calls Waiting" light comes on for subsequent calls after the first. I can't find any doc's that...

Not very, they are on the latest 4.1 patch, but another vendor had been taking care of this network until recently. Could prove useful, thanks.