Recent content by ScottB4803

Thanks!

I'm not sure how to do this, as you can probably tell, I'm pretty ignorant of how this works. I'm a technical support person that occasionally has to re-enable a phone. I'm trying to learn how to reset the time. Can you send the instructions on how to do this?

Type of switch is a Nortel M1/CS1000. My mistake, the code that pops up is TFC007, not the OVL as previously mentioned. The TTAD command works fine to display the date/time. When I type STAD, space, then 29, it drops to the new line displays TFC007.

Yes, one an OVL error.

I tried entering the new time information, but when I try to key the current date/time information, it drops to a new line after I enter the first 2 digits. I type in '29' for the current day, then it goes to a new line. stad 29 11 2011 14 26 10

Hello, can someone tell me how to set the time on the PBX? I found the commands below, but for some reason when I try to use it, I only get it partially entered before it jumps to the next line. Thank you! Changing the Time on the PBX > LD 2 . TTAD (Responds) TUE 04 04 2000 13 25 54 . STAD 4 4...