This MAY or MAY NOT Work but give it a try.
CHA-SBCSU:STNO=3010,CALLOG=ALL;
CHA-SBCSU:STNO=3011CALLOG=ALL;
CHA-SBCSU:STNO=3012CALLOG=ALL;
CHA-SBCSU:STNO=3013,CALLOG=ALL;
Also the other Extensions 3004 && 3009 need it turned on as well
The correct forum on here is called Siemens Hicom
Here is the link to that forum: https://www.tek-tips.com/forums/siemens-hicom.965/
And the link to the FAQ about software etc. for phones: https://www.tek-tips.com/forums/965/faqs/7883
That's normally for trunk groups - Priority is decided in the BUEND AMO and then you assign that priority to a key.
But for end users I think that it might need MLPP (Multi Level Precedence and Protection) - you tell the phone in SDAT what it's level is and you set it up in ZAND and ACSU AMO's -...
OpenScape 4000 V10 Volume 4 IP Solutions Service Documentation Issue 39 Check 2.11.1 General Description
The STMIX can be re-flashed in case the board is not booting or not becoming READY in RMX.
The process can also be used to factory reset an STMIX board. All customer saved data will be...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.