Recent content by sackohammers

Thank you.

Ok, I'll try these things tonight. Can you give me the command to set fa4 to 100mbps? Thanks, Hammers

When I show int fa4 it says its running at full duplex.

I may have spoken a hair too soon. While it is greatly improved, I still get some timeouts. Sometimes hitting the reload button works.... but sometimes that just makes it sit there and timeout. Opening the URL in another window makes it load very quickly... I'm seeing this on two machines...

Hmmm. I have to say, things are greatly improved since adding the "ip tcp adjust-mss 1452 command". I'm not getting timeouts. Things are loading much faster. I'm not seeing any problems with pictures loading on websites. I changed nothing else but that one setting. I'm still on the...

Ok. I added: ip tcp adjust-mss 1452 to int fa4 and int vlan11 I'll monitor tonight.

Ok. I ran a ping -t and times looked good. I also like to use WinMTR and I posted a link to my output. Not one dropped and the averages look good. I'm doing testing here with three machines (one is my server). I get the same behaviour on all three machines. DNS lookups are almost instant, so...

Ok, I did a write erase and started over with the basic config you listed here. Its still pretty laggy. I'm also getting a lot of timeouts like before. For example, it took almost a minute to load slashdot.org's website. CNN came right up one time... almost instantly. The next time, it...

I would just about kill for an "Edit Post" button about right now.

Wups. Posted some info I shouldn't have. Changing passwords to everything now, LOL.

Ok. I tried those and it broke. I couldn't get anything out at all. I copied the "sh run" and will paste it below. I entered: ip inspect MYFW out no ip access-group ACL-INBOUND in so that I could access the internet again. FW#show run Building configuration... Current configuration ...

Is it normal to see all this being logged to my serial session? *Sep 26 02:14:39.407: %SEC-6-IPACCESSLOGP: list ACL-INBOUND denied tcp 24.143.19 2.82(80) -> 67.9.163.19(2831), 1 packet *Sep 26 02:14:49.251: %SEC-6-IPACCESSLOGP: list ACL-INBOUND denied tcp...

I added "ip tcp adjust-mss 1452" to fa4 and the VLANs. This didn't improve performance.

Ah, ok. I thought you said to only do that if I had ADSL. I'll give the first command you listed there a try. Thanks.

Here is "show int fa4" FW#sh int fa4 FastEthernet4 is up, line protocol is up Hardware is PQUICC_FEC, address is 0024.14db.0e6e (bia 0024.14db.0e6e) Internet address is 67.9.163.19/20 MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec, reliability 255/255, txload 1/255, rxload 1/255...