Recent content by power23boy

You can try Hansen software call accounting, product name is Cash

Thanks very much Bkrike and Nortellian for your vote of confidence for the MCK 1000+ extender, I will recommend it to the client.

I would like to be able to access a 6.0 ICS at a single site dose any body know how good the MCK 1000+ Extender works on dialup or on a lease line or if there is any other extender or way to acheive this scenario ?.

Hi to all, In the absents of an analyzer I am not sure what and how many digits I am receiving,What I can say is that when I place my butt set in monitor mode at the demarc point and make a call I can hear the DTMF tones e.g. (totototo- toto)should I be hearing this (toto) at the end of the four...

I know you can transfer outside of the norstar system , when your recpt answer you can either have a speed dial key program with the sales number when recept answers the call press the speed dial key,you can either waite to announce or push the transfer button and release.

Yes This is new to the switch I have place my butt set in monitor mode at the demarc point made a call heard the DTMF tones I was able to call any set with a target line program and got the correct extension, there is a bank of 100 numbers, isn't DIDs auto by default?. Because there is no auto...

I have a problem with analog four DID trunks when you call any number in the group you can here it hit the system, there is a long pause and then a reorder tone is heared but if you redial the last four digits during this pause the correct telephone would ring. What could be my problem?.Is it a...

I am thinking I want to dial extension from system to the other system would this allow me to?.Would I have to use an ATA at one site?. through the gateway and the other site go from the gateway to the trunk card?.

I have a look at the two system to day,one expanded MICS and an ICS compact systems I have never work with the norstar VOIP gateway your help would be appriciated. In this sceanario can I used ADSL between the gateways,this link up is voice only what would be your recomendation.

Thanks Guys, I would be meeting the client on thursday I would have somthing more specific for you guys.

I would like to have some info on connecting norstar systems at two sites. I have not yet found out the software Rls , the two systems are 0x32 and Ics Compact. Thanks a lot any0ne.

First telco assigned to the four analog DID trunks four numbers 419-9990/93 then they made a change to the set up, they withdrew the numbers and program the bank of numbers towards thes four trunks, if I call the first #419-9990 I can hear it hit the switch the other three #s two just give ring...

I have done this test already works just fine can call any ext and talk to it.

Thanks I will get telco to switch to ground start and will let you know the outcome.I was about to ask them to make the change.

Yes I have Install a DID card, I thought these cards were analog. Note: we are not using PRI.