Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by pgatt62

  1. pgatt62

    Nortel Command Set Change?

    Thanks to all who helped, I relayed your advice to the customer and all appears to be well. Cheers Pat
  2. pgatt62

    Nortel Command Set Change?

    Cheers Andy Is this not a bit OTT. The reason for saying this is I'm struggling to get access to the Nortel site for an upgrade. It seems there was no support taken out ????? What about a downgrade if I connect them into the stack? Regards Pat
  3. pgatt62

    Nortel Command Set Change?

    A customer has recently taken receipt of two new Nortel 5530-24tfd switches for back-up purposes and is having difficulty copying the running config of the live switch onto the new switches. The older original switch is firmware version 4.2.0.12 Software version v4.2.0.002 and the new switches...
  4. pgatt62

    Same-security-problems3

    Thanks, I'll let you know first chance I get to pay a return visit. I'll think of an excuse to get over ther soon. Regards pgatt62
  5. pgatt62

    Same-security-problems3

    I'm sorry but I don't have a topology, it is intended that the ASA will be the only gateway to the outside. The only VPN tunnel created and working previous to the ping problem reappearing is the EDI-BRUSS tunnel. Regards pgatt62
  6. pgatt62

    Same-security-problems3

    Unclerico Hi Unclerico, Because this is really an appeal for you to help a complete stranger, this reply has taken me almost an hour to compose. I thought that putting an ip address on the outside address,the inside secure addresses, a default route to the outside interface, a couple of NAT...
  7. pgatt62

    Same-security-problems3

    Hi All I know that this is asking a lot but the config below from a ASA 5520 was hopefully meant to route between both inside secure networks and the outside world. It was also meant to redirect packets that were meant for remote networks connected to other WAN devices connected to the Data G0/1...
  8. pgatt62

    Same-security-traffic problems 2

    hi Unclerico Sorry about the delay in my reply but i've had to drive home from Edinburgh and the traffics been a bit crazy during the Pope's visit today. Wonder how he is with ASA 5520s? Anyway, the cofig below is meant to hopefully act as a firewall and as the routing device between both...
  9. pgatt62

    Same-security-traffic problems 2

    Hi All After appearing to have resolved my earlier problem I now find its back since i've put some extra configs on the ASA. I can get out to the net but cant ping my default gateway or the other inside interface. Anyone any ideas ? Regards etc pgatt62
  10. pgatt62

    Same-security-traffic problems

    You wouldn't believe it but after some further configuration I've lost the ping across internal networks. AAARghhh! Regards pgatt62
  11. pgatt62

    Same-security-traffic problems

    Thanks, thats high praise indeed!
  12. pgatt62

    Same-security-traffic problems

    Hey Unclerico Thanks for the continued support. What I've done is created an ACL for each network and vice versa and then a nat 0 command and its working. Here it is for your perusal same-security-traffic permit inter-interface same-security-traffic permit intra-interface access-list NON-NAT...
  13. pgatt62

    Same-security-traffic problems

    Hello Again Following on from the flash worries, I've now installed the ASA and can access the internet from both G0/1 & G0/2 networks. My only problem is that I acn't ping across the device from hosts on each different network. I've enabled same-security-traffic and icmp inspect in the global...

Part and Inventory Search

Back
Top