Thanks Calum.
That part is working fine.
Only problem is, when I call in from my cellphone (eg 082327xxxx),
The number that shows up on the Yealink Dect IP Phone is exactly the same (082327xxxx).
If I hit redial or call back from the phone history, then it takes the 0 as the digit to get an...
Hi All
What I am trying to set up is as follows :
SIP Gateway Port 1 is Basic to Provider,
Sip Gateway Port 2-12 is Additional for the Above.
Those calls automatically go the Automated Attendant.
Any Phone presses 0, then their call goes out through one of those connections.
I have Sip Gateway...
Hi
My customer has a Panasonic NS500 PBX (Version 9)
I am migrating them over to IP Phones (Yealink), so that in future it will be easier to just replace the PBX itself.
The Customer has reported that since I replaced their existing (Analog) phones with IP Phones, the Automatic Callback Busy is...
Hi All
I have a KX-NS500 With Version 9 Firmware.
I am migrating over from their existing Analog phones to IP Phones. Specifically a bunch of 2nd Hand Yealink SIP-T20P phones.
Their one existing SLT (Analog) phone extension (Extension 144) had a phone outside the Factory, and it had an...
Good Day
We have a Panasonic NS500 PBX.
There is a mixture of the SLT / DPT and Panasonic DECT Wireless Phones.
They have a user group, or similar, assigned to the extensions in each office zone, so that if ANY phone in that area is ringing, they can pick up the call from their extension by...
Good Day.
My Client has a Panasonic KX-TDA100 PABX, Populated as follows:
1 x PSU-M
1 x LCOT16
1 x DLC16
2 x SLC16
1 x CSIF8
1 x IPCMPR
They also have a KV-TVM200 Voicemail system.
Most of the extensions are analogue, but they do have several extensions that are digital (With KXDT321 Phones)...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.