Recent content by nytalkin

Check the RESET button. I had one that was stuck in (engaged).

Does your Nupoint have a GUEST MAILBOX COS? If so is the FCOS feature bit 15 or 287 enabled in it? Disable these feature bits if enabled.

A couple of solutions: Remove Class of Service enablement for WAKEUP from GUEST phone COS/ Wakeup may be controllled from Nupoint voicemail if equipped. Remove WAKEUP enablement from FCOS for GUEST mailboxes.

Could be a CAMP ON callback

If you have access download the system software and the Techncian's Handbook for 3300 Cx

You should be able to Telnet to the ipsocket (1753) used for PMS and monitor it real time. I suppose you're entitled to your opinion, I'm just not going to suppose very hard.

Try this. It's a bit dated but all of the elements are still in use. I suppose you're entitled to your opinion, I'm just not going to suppose very hard.https://files.engineering.com/getfile.aspx?folder=e162cf43-1101-48b6-b352-92f67edddbe5&file=Hospitality.pdf

Typically you will have a minimum of three ip socket connections to a serial convertor. The serial connections are made to the PMS 1) is PMS including maid status, 2) Voicemail connected to a dedicated voicemail system or the embedded vm in your pbx 3) is SMDR. If equipped, the SMDR connects...

You're going to hate this answer but I always used the scripting option in Procomm Plus. I seem to recall the need to run most of the IMAT software in a Windows 95 or 98 formats. (I could be mis-remembering that) It's been quite a while since I had to deal with an NSU. Do you see ant ARP...

Are you trying to config a NSU on a 2K? I've got all of the software going back to 4.0 What do you need? I suppose you're entitled to your opinion, I'm just not going to suppose very hard.

What software is running? Are you using the embedded AA? I suppose you're entitled to your opinion, I'm just not going to suppose very hard.

What software is running? Is ACD enabled on this system? I suppose you're entitled to your opinion, I'm just not going to suppose very hard.

As often as I wished there was, the Mitel genie never granted it. I suppose you're entitled to your opinion, I'm just not going to suppose very hard.

If you have access to the AMC you can use any i-button by simply clearing the hardware id and sync the new ibutton with the ARID. I suppose you're entitled to your opinion, I'm just not going to suppose very hard.

I only ever saw this on old ONS voicemail port integrations. Try a DBMS FULL and see if they show up there as well. I suppose you're entitled to your opinion, I'm just not going to suppose very hard.