Recent content by mvssrt

Done it. Thank you.

Hi, I have programed system speed dial in 8300. It is working from non restricted extns. but not working from outgoing restricted extns. I want to allow only spd dial possible from o/g restricted extns. Anyone guide, how to do? thanks

Hi I activate vrs on analoge trunk in sl 2100, but after welcome msg. my dialed extension not going on same but wrong. Thanks..

Hi, I am facing problem in 9100 pls guide. My two 9100 tie with netlink.problem is that for 15-20 second my slave system down, all phones are blank after few seconds it is working as it is. Alm report shows denied of service. Pls. Guide Thanks

VM to EM Working properly Thanks JR for your tips.

Thank you for reply. I'll try on site.

Hello to all Any one guide about inmail in sv 9100 and in vm to email transfer it is possible conersation rec. aslo transfer with vm msg.? Thanks

Hi, Is it possible to confuger any sv key phone in aspila ex? Or aspila phone to sv systems? Thanks.

Hello, I have a customer using sv8300(400extn+pri+ ipla) They want to expand & replace the system. Can i use any cards of 8300 in 9300 ? Anyone can help & suggest me?

No its not working

HELLO, I have installed sv9100 in hotel, intigration with PMS. All hotel features & CDR working ok but there is one problem that when i call from admin no.(5566) to guest no.(7101), if call is no reply then divert to voicemail group no., At that time, in pms caller no 5566 is shown but callee...

DSP IP for both side already assigned.

Hello all dears, My aspila ex and sl1000 connected in same network and used H.323 Trunks (10-03). SL used lic.free four IP Trunk. Ip calling is possible from both systems but no voice transmission. What is problem anyone can help? Thank you.

Dear, NEC 1 prt card connected with PRI blade of avaya IP 500 NEC 2 link with NEC 1 through ccis. Problem only between NEC 2 and avaya. From NEC 2 to avaya call connect without rbt but disconnect with in seconds. From Ay to N 2 no issue. Thank you for support

Thank you for reply, I have done it but not solved. At nec1 PRI rt 00, for qsig rt 02, ccis rt 20 At NEC 2 ccis rt 20 Problem from nec 2 only.