Currently our organization has an Exhcnage server 2007 enviroment, so i descided that we are going to do a migration to exchange 2013. Everything has went as directed with the co-existed enviroment up until a user that has been migrated from 2007 to 2013 tries to login to OWA.
When the user...
I have an ASA 5520 that i am installing on an internal network. Using the network 10.36.56.0/21 as my example. I want the traffic to pass through the ASA keeping the same internal address on the LAN. would the following static NAT command allow me to NAT the entire subnet?
static...
You will have to bear with me as its been a while sine i have setup L3 on a switch (5 years).
I am workingg with a 4506-E with a 6l-e sup.
I have nothing hooked to the switch at the moment.
When i isses the ip routing command it takes the command but does not place it in the running-config...
We have 2 sups and 5 blades here is a show power:
Supply Model No Type Status Sensor Status
------ ---------------- --------- ----------- ------- -------
PS1 PWR-C45-2800AC AC 2800W good good good
PS2 PWR-C45-2800AC AC 2800W bad/off...
I have a 4510R with redun. power supplies (2800 watts) both connected to an APC UPS. Well over the night our APC died. Problem is i only have 1 240 30 amp plug to run off of until the new UPS arrives. Will there be any problem only running the 4510 off 1 power supply? It seems to be running ok...
I keep the same mind set as you Vince, some of these switches have been up and running for well over two years with no issues. So i am having a hard time talking myself into these upgrades being needed. The only thing that is pushing me towards doing it would be the security of getting ride of...
We currently have 28 Cisco 3560-48PS switches running IOS 12.(25)SEE3-IP-BASE. We recently had to open a TAC case on one of them, and through discussion with the Cisco tech, he recommended upgrading all of these switches IOS to version 12.2(55)SE5-IP-BASE-CRYPTO as the version that is running on...
It sounds like you need to run the mutiple display wizard either from windows or from your video card configuration software. That way you can set your two displays up in "clone" mode and they can both work at the same time.
I installed a Cisco 4510R switch into our datacenter a little over 4 years ago. As you can see by the picture I have attached, the switch has never been powered cycled since its install. The only thing that has been done to the switch every now and again I’ll swap SUP engines, but that has not...
The way i have it sent up with outbound calling i have one trunk tied to an outbond route with the following info:
Outgoing settings
host=XXXXXXXXXXXXXXXX
type=friend
dtmfmode=rtp-nte
allow=ulaw
canreinvite=no
nat=no
insecure=very
qualify=no
reinvite=no
disallow=all
externip=XXXXXXXXXXXXXXX...
To use SIP trunks you will need a CUBE or an Asterisk server for the trunks to terminate to. If you use a CUBE it will need to support SIP inspection to correct your internal to external ip problem. If you use Asterisk you will need to make sure the NAT config is correct.
9 times out of 10 no...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.