Its been so long since Ive worked on a 200ICP. Can I network (VIA IP TRUNKS) a 200ICP that is at 3.0.1.11 to a new 3300ICP MXe? Or do I need to upgrade the 200ICP? Thanks
Thanks for your help but I must have not explained this correctly or in as much detail as needed. I understand ARS perfectly and have even had product support teir 3 look at this and I have it setup correctly we think it might be an issue with the dialogics virtual board. thanks again.
Thanks for all of your help. The IVR is customer supplied and I am not even sure of the make and model of it. Still waiting for a call back for that info. I think the dummy ext/vm hunt might be my best option. Its kind of hard to engineer this without that info but I think Im heading in the...
I have a 3300 MXe MCD 4.2 system. I need a programming solution to interface with an IVR system. We will be connecting the IVR system to the 3300 via 6 to 12 ONS ports. There will be 6 different DIDs that will be calling into this IVR which will then route out to 6 different pharmacies. Each...
Ive tried this. When I create a speed dial 2410 w/ actual number 65500 which points to dialed digits in ARS i have it routing via an IP trunk to MXe2. From there how do I get it to hit the SIP trunk? Ive tried every which way but cannot get it to work. Does anyone have any ideas on how to route...
I have 2 MXe 3300's MCD 4.2 - Incoming DIDs come across MXe1 and outbound calls go out MXe2. I have a fax server that is connected to MXe2. How do I route DIDs from MXe1 to the SIP trunk located on MXe2. I cannot get DIDs to hit the SIP trunk on MXe 2. No matter how I route this. Can anyone shed...
3300MXe MCD 4.2 -How in the world do I route a DID to a SIP trunk. I have a fax server that is linked via a SIP trunk. How to I route DIDs to that SIP trunk. The SIP trunk has no DN so where do I need to point it? Thanks
Is there a command thru maintenance to view the bandwidth usage of the 3300? I know that you can setup some type of bandwidth monitoring but was wondering if there is a simple command to view basic stats?
Mitel 3300 MXe MCD 4.2 - I have a 5330 set that has a multicall of an ext. I need to provide 2 dif caller ids - one for the phone (i have this working thru associated directory number form) but I cannot get a seperate caller id to generate when using the seperate mulitcall ext. When I press the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.