Recent content by mike101876

thank you so much. all is now working. i greatly appreciate you help on this.

no, just the 7 digit number i am forwarding to. they do not dial 9 for outside lines. i may as well ask now, how do i find my ACOD if needed?

it seems that it will only allow me to ncfw 4 digits

this is not going well, ci remember doing this in the past now that you mention it (the ACD) but now i get SCH0430 invalid DN when i enter the number to forward to. sorry to be such a pain.

I cannot find that thread, if you could post the link that would be great thanks

thanks! i will look at that post. btw, i have used your website in the past and your notes have been a great help.

oh wow, it has been a while, what load do i chang the rdr_data / OPT in?

i see cff but not cfo, shoulf i add the cfo?

Not exactly, i am offsite and the customer never cfw the lines. they were working lines when i changed their dn (didnt want to remove until i was sure it would work) then i used that DN on the new phontom. i am def using Phantoms, they are 156 0 11 0. sorry i cannot pull the TNB at this time but...

ok, now the customer has decided that this is a permenant setup and that the phones need to be removed. i am trying to use phantoms to cfw the lines but everytime my test calls hit the system i get an error message that the line i am calling has been disconected. they are known working lines and...

great! thank you very much.

how quickly i forget, former PBX tech forgets the simplest commands. i have been out of the PBXs for a while and cannot remember how to forward an analog set to an external number. it is a local call. any help is appreciated!

Thank you, I also have another question to this, this is a dual cabinet option 11 and i have a spare dti/pri card on hand. is it possible for me to build this PRI as a second connection and later remove the tie line or would it be best to convert the tie to what i need, please keep in mind i am...

I am trying to allow the caller id to pass between my opting 11 to a mitel PBX. currently i have a point to point TIE line connecting them. what is the best solution to allow my system to pass the caller id on a 911 call to the Mitel. do i need a pri instead. the option 11 is a remote node...

thank you, it is so simple but i couldnt figure it out. thanks again