Recent content by Matt Scott

OzzieGeorge, I switched these to normal instead of DID - I still get a busy tone when calling - if I cut off the SIP Trunk Providers access I just get dead air and it hangs up CoralTech, I am not sur what you mean by config - there are 20ish phones and they work with the current POTS lines. I...

in 22-02 on the Trunk for the SIP are all set to DID sip alg is disabled/not an option on this firewall

daddybadger, Thank you for your reply. Still no luck do my best to research and see what I can do. I feel like its going to be just one small change that is being overlooked :-( Thank you all for tips to review! A suggestion was made to have the SIP Trunk provider only provide the last 4 of...

Bigdave1980, Glad you got it working. I have a question, with SIP Trunk licensing do you need to have multiple licenses to be able to place multiple calls even if the provider accepts multiple calls using the one sip trunk account information?

They are sending and looking for the full 10 digit DID phone number I have not tested to call outbound using the SIP Trunk yet

Don, THANK YOU very prompt response! - I'm not sure if this is the same thing but I have setup 22-11 (DID Translation Table) to the target extension I would like it to go. however the 22-11-01 received number is only the last 4 of the DID only allows for 8 characters. I am semi-new to NEC PBX...

We have a SL2100 with POTS lines and now I am trying to convert the SL2100 to SIP Trunks. I have added the SIP Trunk (IP based authentication) and added other routing for that SIP Trunk but all I get is a Busy tone when calling in. Any tips or things I should double check on? I see the calls...