Recent content by Longhorn69

All is well. Was able to get in and change the ip address after getting the correct login and pwd from the Vendor.

Ok was able to get screen using a monitor and key board. Login with Administrator and get" Session setup problem, abort." Tried system-config-network and got "bash system-config-network". Just need to go in and change the IP address on the module and I can go home. VMPRO is still working ok.

Thanks for the responses.

Have you tried the ip addy of the IP Office with a 7070? That's the default webcontrol address when it first comes up. IE 192.168.20.1:7070 Another tech friend suggested that also. Customer is getting a new module shipped to site. He's aware messages and greetings will be lost. My question is...

Going to re-initialize the module with the monitor connected. Can't reach it thru VM Client or Manager either. So the IP 169.254.0.1 is what's suppose to be the IP for the UC Module? The installer has 172.140.1.6 which is incorrect and didn't install Client, I have it installed now on the...

I'll try tomorrow when I go back on site. Thanks.

Tried using a monitor on the HDMI Port and Keyboard on USB port and "no signal on Monitor." HDMI works in Conf Room. Used web browser and couldn't get to IP address on UC Module. I can see it in Manager under Control Unit. Installer used wrong IP address and now we can't even ping it on the...