Recent content by JudyS

My Canon BJC-4000 was not detecting the cartridges, so I bought and put in a new BC-21e Cartridge/Printhead Assembly with new ink tanks and am still having the same problem. When I power on the printer, it beeps once and the printhead goes back and forth and then to the center. Then it beeps...

Hi,<br><br>All that I know about the memory sticks is that they are from a Compact Presario and 60ns (Part#137143-001). They are 72pin 16meg with gold leads and 9 chips on each stick. I borrowed from a friend, an old DFI 486 board that also uses the P24T (PODP5V) Overdrive Processor and same...

Hi,<br>The motherboard settings that I have listed in the link up in my first post (<A HREF="http://www.dragonherbarium.com/mobobios/m&b-set.txt" TARGET="_new">http://www.dragonherbarium.com/mobobios/m&b-set.txt</A>) are from the 486- GIO-VT2 manual that I downloaded from the FIC (First...

Hi,<br>I put this little hard drive&nbsp;&nbsp;in, because it was the faithful boot drive for an old 386 I have (with Dos6.22 on it) that I know works, and also just incase this setup couldn't handle a Large hard drive, I wouldn't have that going on too. I have tried to boot from a boot<br>disk...

Hi,<br>I have a 486 motherboard, (used, but new to me, I've never seen it fired up before). The board didn't come with a CPU, so I put an Intel Overdrive P24T (PDOVP5) on it and maxed out the ram to 64meg (all matching sticks & leads). I set what jumpers that I could figure out, put in a video...