Recent content by jpruder

I would do a backup and restore, as this should get rid of corruption

I would agree, I also assume this to be some type of sip ata and most if not all can do some type of cpc drop of loop current now a days.

If that is the case, perhaps they use Nupoint and he is looking in the wrong spot

That is a maintenance command i.e. DBMS Check Full to see if there are database errors

Does DBMS Check full show any errors?

You might try to turn off any device based option in the sip device setting and see what it may do

Does mailbox 0 have 7000 as it's extension?

If you have not gotten this, here is my link for what I know was the last version of firmware for this that was released within a version load. https://drive.google.com/file/d/1K_0L8tL90O0aI-rpueyjr2z-M6lLXkNO/view?usp=sharing

Think it should be no and yes for those two

I would check cos for a display dnis before answer option

Can you perform a full ftp backup? You should be able to create an install compact flash and use it to get the new embedded one working. Then do a restore.

Trunk attribute Dial-In Trunks Incoming Digit Modification - Absorb should have a zero and Direct Inward Dialing Service should be on. This is assuming you are getting 10 digits and there are entries in the DID form

You will need a routing rule think a wildcard is uri * going to desired controller

In theory, you could install a default database, back it up and then change the installer passwords on maint and cde. Do another backup and compare the file differences. Then making sure you have 2 current backups, edit the hex on one setting it to the default values, restore it and see if it...

Usually sent up an account code that it overrides any class of restriction for the international call dailed number