Recent content by johnPlayer1

Thank you for the elaboration. This was the solution to my problem. I used the QTT feature. Thank you CMUK Obtsystems Ired1980. Stay safe everyone.🙂 ~johnPlayer1

The issue has been resolved. Thank you for all the reply. Let's all stay safe.🙂

Thank you for the reply. 🙂

thank you for the reply. yes, the co lines are analog. when connected directly with a standard phone. the line times out when caller hook-on the phone. here is a view of the set up: CO line (call) ---> [PABX (configured features: DISA-ICDG-DIL)] ---> operator before, outside calls with DISA...

Thank you Ired1980. I will try to use to clear button.

Thank you for the reply. I have a reply a while ago but i'll revise. it was vague. [peace] I've concluded that the CO line was the problem but after going through the reply of CMUK. and going through the process of the call. I thought what if it's not the CO. so: Is there a setting in kx ns300...

Hello! Again😁 Is there a feature on kx ns300 where i can configure the CO line? The CO line is disconnecting prematurely when no answer like 30 or 40 sec. Thank you! Stay safe everyone! -john

Thank you obtsystems. 🙂That is what is lacking in the config.Got the system working as required. Stay safe everyone.🙂

Hello! I hope everyone's safe🙂 Can anyone please help me with the following: System: kx ns300 602: ext.: 201, 202, 203 603: ext.: 201, 202, 203 1.) When caller connect to 602 from DISA ext. 201 should ring first, then 202, then 203 after 5rings. 2.) When caller connecta to 603 from DISA ext...

Thank you Mike. I checked the file it was .wav(mono) so iwent over my notes.. 🤦‍♂️My bad, i was uploading the ogm file to "file transfer pc to pbx" when i should be uploading it to "message file transfer pc to pbx." I'm uploading it for DISA. Fyi to my fellow noob😅✌. I would like to ask...

Hello. Help please.. 🙂 I was trying to upload a .wav for ogm but i got the error "this file cannot transfer from maintenance console". The wav file is less than 1mb and less than 1min. Any advice please? Thank you in advance!🙂

Yeah, i did put back the cards.. reset and restore. Cards and pbx is working again. ☺ The slc card that was "dead" from the start was the only one with no changes. Maybe it already needs replacement. Thank you very much to you all. Keep safe!

I checked all the fuse with a multi tester. All of them have continuity. Are there other options how can i check the cards if possible? How often does the main board of the KX TDA 200 get damaged if anyone knows? The system I'm trying to fix been running since 2007. Please bear with me I'm...

thank you Mike. will do check the voltage on those points. If there are problems in the control points. should i let the board fixed or replace it with a new board?

Hello! Can you please help me how should I start to troubleshoot the PBX shown in the image. By the way SLT card #6 light is off ( i think it's a dead card). Thank you in Advance. Keep safe everyone!