Recent content by GuestAdmin

Thank you all for your help

Hello All, Please can you help me with generating a report on Cisco CME CLI something similar to Cisco UCM - Summary of device counts (I know UCM is for enterprise so there are many advanced features which CME wouldn't have) How would i generate a report by phone models currently configured...

Thank you all for your reply. Can I then please confirm one question, that means if I add any new phones on the network which came with the factory default firmware they will still retain their firmware no matter, what it is?

The problem basically is on our system, when we run the report there are few phones appearing with mismatched load, all the phones are on this load SCCP42.9-3-1SR1-1, whereas the default load is SCCP42.9-1-1SR1-1. However, from the CLI I have found there is no SCCP42.9-3-1SR1-1 on the Server...

Furthermore on this, I managed to connect to UCM through CLI and listed all the files using the command list files tftp / page and cannot find SCCP42.9-3-1SR1S anywhere, it seems those phones plugged in have the firmware factory installed on them. The other option, I wanted to try was to...

Did you mean the firmware currently on the Server is already SCCP42.9-3-1SR1-1, as all the phones are registered with it. However, the device default is set to SCCP42.9-1-1SR1-1S, this is what I should copy to Phone load under the actual phone configuration to bring it to the same load level? I...

I checked the phone's setting and found the field you are referring to, it's called load name and at the moment it is blank. How do i find the loadname for this firmware, SCCP42.9-1-1SR1-1S? or do I enter this in that field? Also, I logged onto OS Admin page and the only place where i could see...

How do I check my Server to see if the firmware SCCP42.9-3-1SR1-1S is already on the Server? Also, can i change the device defaults without causing any issues to already registered phones? Or, is there a way to change the firmware for one phone from SCCP42.9-3-1SR1-1S to 42.9-1? and how...

Hello, Why would the active Load ID on my cisco phones would be higher than the default Load ID configured on the system? Active Load ID is SCCP42.9-3-1SR1-1S whereas default is 42.9-1. and how can I put the phones on the same load as the default? Thank you

Thank you

Hello All, I am new to Cisco Voice world and currently have received a request to setup templates on Cisco UCM for Phones. I have created a template under Bulk Administration -> Phones -> Phone Template for Cisco 7945 model with the settings I need. Once the setting was saved, I modified the...