Recent content by gregworcester

Hi Folks It ended up being the statement ip verify unicast reverse-path on fa0/0 that was causing the issue. Thanks everyone.

Thanks viconsul. I added the correct ip route statement but this did not help matters. By all rights this should be working. Here is my config again a little shortened for clarity. If antone sees anything that could be causing no connectivity, I would appreciate some advice on how to proceed...

Hello, You folks helped me with this router when I had trouble configuring it for an ADSL wic card. My ISP is discontinuing the dsl and I have went with Time Warner access. ( Broadband ) The config is posted below, I can ping on the outside, but cannot get out. Any help would be appreciated...

Hello, hope someone can help me with this. I am running a school network with about 75 users. We upgraded over the summer to a cisco 2821 router. We are having connectivity issues all over the school now. Some machines are ok, others are showing limited connectivity, in some cases a machines...

Got this working. Used the built-in CPExpress. So much for my manual config skills. Think it was the name servers in the dhcp pool and a few other things. Thanks

Thanks for the reply Quinceocha. I changed the overload statement to the outside interface. Now I cant ping from the router console. This one is being a pain. New config. no ip source-route ! ! ip cef ip dhcp excluded-address 192.168.0.2 192.168.0.20 ip dhcp excluded-address...

Hi Guys, TRrying to setup a new 2821 router. I can ping 4.2.2.2, google etc from the console of the router, but cant seem to ping anything on my inside network. Config is below. MadisonEl# wr Building configuration... [OK] MadisonEl# %Error opening tftp://255.255.255.255/network-confg (Timed...

Hi vince. I have not made any changes as of yet. I think I understand what you are driving at. I wanted to supply complete info before I proceed. As follows: from router fa0/0 to port fa0/1 on 2950, nothing configured on switchport. from router fa0/1 to port fa0/12 on 2950, configured as...

Hi Vince, thanks for the feedback. Tex-tips (burtsbees) mostly help me setup this router. It is a 2621 with a ADSL WIC card in it. The two Fastethernet configs my ISP sent to me. The way i understand it, the fa0/0 is doing DHCP to grab the IP of the ISP from the ATM sub-interface, my FA0/1 is my...

Hi guys Sorry about that. Did not mean to be short. Here is my final config. Added encapsulation dot1Q 101 native to the .101 sub-interface seemed to do the trick. Here is the config. Any additional suggestions would be welcome. ip dhcp pool whitepine import all network 192.168.0.0...

Hi guys, thanks for the help. Figured it out, and the vlans.

I do it is ip route 216.107.224.0 255.255.255.254 192.168.0.0

OMG. the encapsulation is pointing to 101. Sorry

That fastethernet is wrong in my previous post. It is Fa0/1.101 on the router.

Hi Guys. Thanks for all the responses. I have dumped the vlans for the moment and i am trying to get my network communicating with my default gateway configured on a sub of FA0/1. As suggested by unclerico. If I can get this working, then i will play with vlans. Below is config i added to...