Recent content by gaibut

I have a issue with a power slot in a 1001 RP, I have known good power supplies.I have another 1001 RP that was previously loaded with 1.07.Should I have any concerns if I move all 6 drives, raid controller, cpu to new 1001 RP.Mother board same on both 1001 RP.

I have seen all the cinphony threads , I am wondering has anybody found the fix to this issue, or did cintech help

I see in the infocus when pulling data from cinphony i can see packet, how ever the report's that are coming up are from 2 years ago, do I need to start anything in infocus server?...also intialize engine comes up when trying to produce reports, ran chkdsk and show file allocation errors in...

Trying to replace a dead drive at scsi 1 / 5, found drive that will come on line but when trying to rebuild the dac960 raid software comes back and says wrong device. Using the documentation that I have from Nortel it says to click on the drive you have replaced. But the example shows drives 0...

Is the client software on a separate CD or can I pull off a copy from the symposium express server?

LD 22 PRT ISSP

That sounds like a great idea to remove the tape drive , unfortunately I do not see it currently

Call Pilot cannot complete backup, cannot see Tandberg SLR75 External Tape Drive, I remember a bulletin on this issue about a bad scsi cable , any ideas?

When you report Health Maintenance issues to your customer , only to be asked " Has the end user reported any issues ? ",and then your customer ask the question, " Why should I out the 300 disabled sets in the PBX ? "...

Thank you for your response, might be tough to get 25.30 patches, but I can certainly take away load 30..

what type of call pilot do you have?

I just reloaded software on a 1001 rp, everything is working fine, except at midnights the MGate card disables and I get a error message CDN003 , default application, I will soon add latest updates SU05 and will change NIC card to half duplex and 10bps..currently set to auto.If this does not...

If you have a Call Pilot can it be moved to another site were the Serial numbers do not match the PBX. I believe there was a issue with Meridian Mail matching but not sure with Call Pilot. I have a site were I have a good 2.02 1001RP Call Pilot but want to move to another site that has a down...

There is no caller id for system and no voicemail

When a user is on line one and they recieve a intercom call to that set it will not display or change lcd on set. If the caller hangs up and calls again when the user is still on line one then it will display and let user know who is calling.I have tested this on different releases of Northstar...