Recent content by EugeneMc132

Hi, I have 2 sites (one is a CS1000M and the other is a BCM 400) that are interconnected via H.323 trunks, and I have abbreviated dialing set up between the sites. Problem is that there are still those that like to pick up and dial full 10 digit numbers between the sites over long distance...

SUCCESS!!!!! The busy signal was because I hadn't changed the CTYP in my DMI table to CDP, so it was still trying to shove it out over the PRI. Once I did that, bingo!!! I feel like singing!!! Thanks again guys for the help!!!

Yep, that's exactly what I did, and it worked to get the alternate routing in. Getting a busy signal when I'm dialing inside alternate portion of the routing, but everything else outside of it in that area code works fine. Gonna do some TRAC's to see what I'm missing. I'll post what I find...

Thanks for that. Tried it, and it gave me an ESN080, which says "No more available SDR blocks (out or expand MXSD)". Looks like that MXSD value of 0 ain't cutting the mustard as they say.

Thanks Gene, this looks exactly what I am looking for. One problem though. When I create the SPN, I am not given the ARRN or ARLI prompts. I did a little digging, and found another thread talking about ARRN http://www.tek-tips.com/viewthread.cfm?qid=962253&page=961 and was checking some of...

Hi, I'm a regular reader, but a new poster, and could use some help with something I'm working on. I have 3 sites, 2 of them have CS1000's and the third has a BCM400. We have routing setup through CDP to send calls between the sites using H.323, and it works perfectly. My question is, as one...