Recent content by Dinkytoy

That will require some dns being set up with an A record pointing at the IP address bound to the website. Once that was setup, if you wanted to restrict it so only the name could be used (i.e not the IP) you could use a host header which is setup from the bindings (iirc).

I typically delete the default site. Check the bindings, though, this links the sites with the IP addresses on the server. 1 site per IP address or you will need host headers (assuming default ports).

Fault found, problem server side with nic drivers.

Hi, Got an issue I'm banging my head against the wall. I've hooked up a Cisco 2960 to a Dell M6348 over an etherchannel trunk supporting 2 VLANS. The Cisco switch is happy as larry as far as I can see. DMZ2#show run int po3 Building configuration... Current configuration : 117 bytes ...

Congratz :). I'd pick up CCNA Security book and the ROUTE book and see what you feel more comfortable with. You might want more of EIGRP and OSPF etc or you might be slightly sick of them ;).

If you have used the public server wizard to create the NAT rules then there will be NAT rules created for inbound and outbound. I'm not familiar with the specifics of your load balancer but the ones we use require the VIP IP address to be used on the loopback adapter of the server. This means...

The the sonicwall is probably being over sensitive. However, it's best to check and as they are from inside you can trace the machines back via IP/MAC Addresses and see if there is anything funny going on.

I think that's CCIP for MPLS from memory. I think CCIP covers BGP, MPLS and QOS.

A lot of companies follow this kind of test setup. My current company has a REALLY evil set of development questions and the interviews and exam can take 4 hours and only about 1 in 10 or 1 in 20 pass that get that far and to get that far they've already gone through a phone interview and an...

Check the bios version, some older bios do funny things with larger modules. Flash it up to the latest and I suspect it will be fine.

What model Sonicwall do you have? Have you checked the Zones that the interfaces are designated and any relevent ACLs within the firewall?

If you are getting a NAT lab in your exam, it's something I almost stuffed up. Know the difference between the extended and basic lists, I got into the habit of using extended during my practice and the exam called for a basic. The config would have worked perfectly but that wasn't the point...

I had a stab at it in April. I have to agree that it is wordy and prone to errors. I found a completely screwed up question that had no correct answer, I almost ran out of time due to the time spent 'making comments' on it. I didn't pass it in the end, but not due directly to that question. I...

If it helps anyone, the scenario is similar to that of the OP on: http://www.winserverkb.com/Uwe/Forum.aspx/windows-server-ad/13807/Cross-forest-authentication-across-a-firewall No solution was presented though.

Just FYI I don't know if this is new or not, but it seems Cisco themselves have started doing virtualised labs for many of their certs. May be worth checking out, I don't know how good they are or are not, but pricing seems reasonable. Main site...