Recent content by cisco222

Hi, I have been asked the following questions off one of my server engineers we have 2 sites connected via a IPsec VPN over 2 ASA's Site A - 10.0.0.0 subnet which hosts all the internal server inc the SMTP which is on 10.0.0.11 Site B - 192.168.25.0 - no servers here I have been asked...

I'm currently studying for my CCNA Securtiy 640-554 IINS exam. I want to be able to play with cisco configuration professional software and use policy maps and police traffic. Can anyone advise a cheap model of router that can do this? I have some old Cisco 837's however they don't support some...

I have a Cisco 5505 firewall and have a single Cisco access point plugged into the POE port 7. On my wireless AP ( AP1142N ) I have 2 ssid's one for production vlan 1 and vlan 10 for my guest's. I want vlan 10 only to have access to the internet and nothing else, so they cannot access vlan 1...

2 ISP's 2 gateways Static Route Tracking example R1(config)# ip route 0.0.0.0 0.0.0.0 2.2.2.2 R1(config)# ip route 0.0.0.0 0.0.0.0 3.3.3.3 10 if the 2.2.2.2 network goes down it will use 3.3.3.3 however when as ISP goes down the gateway usually stays up so can i can track the link of the...

Hi Guys, I'm currently studying for my CCNP - Switching I was looking to setup HRSP in packet tracer however it doesn't seem to have the correct commands withing 3560 multilayer switch! I would like to purchase some equipment off the internet, which type of layer 3 switches would work at a...

the network 172.25.0.0 has been devided into 8 equal subnets. Which of the following ip addresses can be assigned to in the third subnet if the ip- subnet zero is configured on the router? Possible Answers A= 172.25.78.243 B=172.98.16 C=172.25.72.0 D=172.25.94.255 E=172.25.96.17...

Thanks for your help guys!

Thanks. How did you workout 192.1.159 255 is the a quick way i can work this out? is it because 11111111.11111111.11110000.00000000 this = /20 do i need to increment by 16 in the 3rd octet to get my answer?

anyone know how they got to this answer?

Answer is A and D by the way!

The Ethernet networks connected to router R1 in the graphic have been summarized for router R2 as 192.1.144.0/20. Which of the following packet destination addresses will R2 forward to R1, according to this summary? (Choose two.) A. 192.1.159.2 B. 192.1.160.11 C. 192.1.138.41 D...

so i would create an additional interface on both the asa and the fortigate say on vlan 10 both on 172.16..0.0 network plug them into the switch and allow then vlans through the switch?

we have just implemented a cisco asa 5510 onto an existing network which runs along side a Fortigate they are not connected in any way. I need to get both networks talkig to each other, i'm struggling to think of the best way to do this. see network below Network A...

thanks for the update.do i need to assign an IP to my management Interface currently i have the below. Please advise interface GigabitEthernet0/0 nameif inside security-level 100 ip address 10.200.0.254 255.255.255.0 interface Management0/0 nameif management security-level 100 no ip...

Thanks for this. Made it nice and easy to understand.