Recent content by bojo3871

Thanks, jpruder! The other setting I needed was for #2: Display Dialed Digits during Outgoing Calls Yes

Thanks! For the incoming CLI, I narrowed it down to these 2 at the user CoS (set to YES): Display ANI/DNIS/ISDN Calling/Called Number Display ANI/ISDN Calling Number Only For #2, I need to compare as the other lab system I have works normally but it is likely CoS as well.

Some progress... Outgoing call now works though there are still some issues. Under Trunks > Enterprise Gateway > Gateway Configuration Script, I changed the default configuration file from whatever what was set to the Mitel Euro Standard cfg. But I still have these: 1. While the incoming is...

unfortunately, it is not the DPNSS access as I have that enabled in the Trunk's and user's COS. Any more ideas? I'll try to do a syslog trace on the EX side to try and find more clues.

Hi all, MiVB Software: 10.2.0.57 Controller: EX I'm having issues with E1 on the EX-Controller. 1. Incoming call works but the CLIP while ringing shows the DDI of the user (B-number). Once connected, it updates to the correct A-number. 2. For outgoing calls, the MiNet phone immediately...

What do the SIP trace from MBG show?

Could you explain your call scenario? I'm not sure if what you are asking is simply an access code as in ARS leading digit or Independent Account Code where the user needs this access code or PIN to dial an International number.

I'm curious if this ended up being faulty hardware?

What do you see from DGT TRACE? DGT TRACE <dialed number>

Maybe check the registration (renewal) timer? What is set on the PBX side vs the phone?

I actually can't find any available for sale. It just so happened our partner has one. I am also looking for some for my team and tried to reach out to the manufacturer (check Alibaba) but have not got any response back. I see some in ebay but they are also no longer available.

MiVB 10.1.1.21 SMB Controller I am supporting a regional partner who have a few CO lines. Some lines support DTMF caller ID and others FSK caller ID. The CLID does not work when the CO lines are connected to the MiVB's SMBC FXO port directly. However, the CLID works if they use a DTMF <=> FSK...

Mitel KMS has an article on Virgin Media Business SIP Trunk using MBG. (Assuming you have a MiAccess account)

This was from an MiVB presentation. I think the hotel capacity for up to 300 endpoints may be due to lower expected traffic. MiVoice Business on SMBC can support: Integrated MPA probe Integrated MBG functionality for SIP Trunking, Teleworker and Mobility Integrated CloudLink Gateway for add-on...

And the solution was? I'm sure it would be helpful for others... I hope we make it a habit to share what we learn as that is the essence of the forum.