Recent content by bishoptf

I think what I am going to do is to create some sip lines and have them assign me a did and add it into the mix but then add a short code that will allow me to test outgoing and incoming calls while allowing them to continue to use the existing analog circuits. Once I have tested and feel like...

Like the title says I have a small business that I have upgraded to 11.0 version and purchased SIP trunk licenses and looking for best way to migrate the service from our existing analog lines. Currently we have about 4 ananlong circuits that act as trunks with 2 inbound DID's for different...

Thanks for all the suggestions!

Yeah sorry, I am located in the US, I was originally looking at flowroute but started seeing that support had gone downhill since they have been sold etc...voip.ms from what I have read is a mixed bag. For me it's not about the lowest cost, its more about support and reliability, if I do have...

Understand, I was just trying to see who folks were using provider wise that were providing reliable service and responsive support, etc...

Skyetel was one of the ones on our list, but was just trying to see who other folks were using and how good the reliability and support was...

Just wondering what are folks using today that works well with IP Office. I have a small church that want to move from analog lines(4) to SIP trunking. Would like to go with a per minute provider since they do not use many minutes, pretty simple setup. Not looking for necessarily the cheapest...

There are 2 echo settings echo cancellation and echo reduction, did you turn both of those off? Thanks

Understand and appreciate the input, I will be on site this weekend and make sure the ground is good and run the impedance tool manually on each line

The cabinet that its in is properly grounded, I am pretty anal about that stuff but I do not have a connection from the grounding lug to the cabinet, I can do that but im sure if I metered it out I would see that it is grounded properly since its connected to the cabinet rails to the chassis but...

I know, I know we are in the process of migrating to SIP trunk but I needed to upgrade in order to be able to purchase the SIP trunk licenses. We upgraded from 8.0 to 11.o and that seemed to go well, no major issues but I have users now complaining about echo where they were fine before. We have...

They are running embedded voicemail as far as I know, that is a good question it appears that the consensus is 11.0 is much more stable than 11.1, is there any version of 11.1 that most feel is stable or should I just avoid 11.1?

Yup my question is I need to replace the 4g Avaya SD card with an 8G Avaya SD card and trying to figure out when to do that, I have read that sometimes the older 4g cards cause some issues. So do I swap out the card in the beginning or after upgrading to 8.1.95 etc...The other thing is I have 2...

I am working on the steps for upgrading an v2 system from r8 to r11.1, I know I will need to make a step upgrade to update the bootloader and have the basic steps outlined, here is what I am working on steps wise, system is running all 96xx phones about 33 endpoints, no voicemail pro, essential...

I am trying to get some recommendations for vendors in the St. Louis area that can upgrade software for an IP office system. Currently we have analog trunks and would like to migrate to SIP trunks but cannot purchase the licenses since our software versions are no longer supported. I have looked...