Recent content by bboyko

The January Lifecycle Dates document from Avaya shows July 1, 2016 as end of services support for 4.0 and 4.5

The IP Phone Fundamentals NTP for 4.5 says to configure an 1150E as an IPACD set type in LD 11.

Also, the signalling servers and cards should have 'Enable Line TPS' checked in the node configuration

For 5.5, I like to telnet or SSH to the SS, and use the following CLI commands: pbxLinkShow - to make sure that the SS and the call server are communicating. electShow - to see the status of the SS and cards. tpsShow - to see the status of terminal proxy service. In 5.5, if the SS is down, the...

Make sure that the DCH daughter is an NTBK51AA or NTBK51CA dual DCH daughter board. The NTBK51BA only has a single DCH, and is used in small systems.

On the D channel, since the Nortel is set to 'usr', the Ascom would need to be set as 'network' or 'master'. Sorry, I don't know what Ascom calls it.

Mail backup to tape works fine. However, when I try to write a bulk provisioning set to tape, I get the same error, 1007. Then I can't delete the bulk provisioning set, because of a "customer doesn't exist" error.

We are using 6140 handsets with a CS1000E 7.5 system. You don't need the application gateway. If you are using Spectralink phones like the Nortel 6120 or 6140, you do need a 2245 wlan IP telephony manager.

Thanks for the quick responses. We went through the mail boxes and assigned every one to a class of service before we attempted the migration. This appears to be related to data corruption of some kind.

I have a MerMail Modular EC 12 system, with about 3400 local users. When I try to collect user data for a Call Pilot migration, it only writes about 220 users to the tape. The migration log on Meridian Mail shows several errors like : MMER1 - 0:0:41524 Rc = 1007 and MMER1 - 0:0:41899 Rc = 3001...