Recent content by AELMAN

Is there anyway to map a CLID to a ACD queue that is NCFW to an outsided line. When calling into the DID through SIP and going out on a PRI coverted to SIP the number is blocked because it is not sending a CLID. See Trace Example DCH 16 UIPE_OMSG CC_SETUP_REQ REF 00003554 CH 25 12 TOD 9:46:45...

We notice when we transfer our DID's from a tradition PRI service to CO SIP Service from verizon. fax calls routing from PSTN sites utilizing TDM service goes right to our phone. Fax calls utilizing SIP service over the PSTN work fine. Has anyone had this problem?

Has anyone experienced any problems when using one number fax with incoming SIP DID's?

I have CS1K 6.0 anc CallPilot 5.0 . We are using one number fax as part of the call pilot feature. . When we switched our DID's to come over Verizon SIP trunk we started having problems with the one number fax. We notice we can not recieve fax calls when the calls are made from TDM sources into...

Your the man, we got it working great now.. thanks for all the help..

how do you get 1NPANXXXXXX to show in you calling number field what did you program in you PBX. i found out that i needed to up the Ncos to get international calls to work

Can not get the full 10 digit caller id to display on a PSTN call to an outside phone. any ideas

thread798-1589491 Can not seem to get international calls to route through the MP-112, always seeing 100 and 100011 being delete for international calls national calls are working fine .trac 200 0 0 0 dev ACTIVE VTN 200 0 00 00 ORIG VTN 200 0 00 00 IPTI RMBR 20 1 INCOMING VOIP GW CALL...

Ok I guess its the same workaround as in the callpilot unkn and unkn. The only problem with this is what happens to inccoming international numbers.

TYPE NET_DATA CUST 00 OPT RTD AC1 INTL NPA SPN NXX LOC AC2 FNP YES ISDN YES VPNI 1 PNI 1 PINX_DN MBG 0 BSGC 65535 PFX1 732 PFX2 512 HLOC LSC RCNT 5 PSTN NO TNDM 15 PCMC 15 SATD 1 OCLI NO DITI NO TRNX YES EXTT YES FTOP FTLY VNR NO NIT 8 NAS_ATCL...

TYPE RDB CUST 00 ROUT 31 DES COSIP TKTP TIE M911P NO ESN NO CNVT NO SAT NO RCLS EXT VTRK YES ZONE 030 PCID SIP CRID NO NODE 1050 DTRK NO ISDN YES MODE ISLD DCH 30 IFC SL1 PNI 00001 NCNA YES NCRD YES TRO YES FALT NO CTYP CDP...

**DAPC**PREFIX TABLE NO: 01 ** UNKN**INTL**NATL**ESPN**LOCL**ELOC**ECDP** UNKN* E164* 900 91 PRIV* E163* 900 91 TELX*...

can you tell me where to put the 91 and 9011 . This is SIP trunks coming from the CO not internal

Yes, had to for E911 anyway

Is there away to add a 91 into the caller list on calls that come in over CO SIP trunks. DAPC table works for PRI, but not SIP calls, how do I make these calls have a 91 infront of the national number and 9011 over international numbers in the callers list on the phone.