Recent content by admtct1

Venders, I have a few questions for programming and hardware installation. Looking for some advice and support.. System Info: 3 Co Lines, 3 Stations and 1 Single line phone with a paging system 1.) All the above is working as it should except the Single Line Phone (Station 148, using a...

I was able to replace the battery without removing the board from the case on the 3500 series KSU's, little tricky on the (-) side due to how close it is to other circuitry. With a small enough tip on your soilding-iron, seemed to work for the job.

FYI:I was able to speak with a local Tech over the phone and he gave me something close to the same advice you did. 1.) Turn Off 2.) move Dip switch #8 to ON 3.) Turn power back on 4.) move Dip switch #8 to OFF 5.) Push the reset button next the the battery On/Off switch This should take it...

Mforrence, I took all cards out and ran through all the steps metioned above. It seems that **3226 is not allowing me to go into program mode. I have working on contacting a local tech that may be able to help me out and showing me what I am missing here. Thanks for the infomation you gave me.

I am getting that display with all cards in, should I have taken all cards out and then reset the system? And to be clear, when you mention base phone on the KSU that is the #10/100 location? I believe that's what your talking about but I don't want to assume that. I have not tried resetting the...

Thanks, I have walk through the steps of logging in and had no luck. I feel I am missing a step here. None of the Keys will respond when I try to do so. After resetting the KSU,I had a different message come up on the display and it read; LKD-24BD V0.0 00/00 '00V1.1 OK SYNC.. Hope this helps...

It looks like I was able to set it back to default, the phone display is showing LKD-24BD V0.3 00/00 '00V1.1 OK SYNC I hope this helps. Thanks again up front for any advice given to my cluster!!

Good Day Gents!! I am working on a STS Vodavi 3500 system. I have replaced the battery and I am still having trouble getting in program mode. Can someone help me with this? The KSU turns on and the phone display read LKD-24BD V0.3 Scout-DX V1.1 OK SYNC..I have a V70 Basic SL1B Card, V70 DT1B...