Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by aaronphone

  1. aaronphone

    NEC SV9100 registering yeahlink DECT Phones

    Hi All, Im using the following; SV9100 fully licenced, using 9.00.79 firmware (192.168.0.70) 1 x Yealink W60B with 2 x DECT handsets (192.168.0.250) DECT 1 - X-370 DECT 2 - X-371 Trying to register X-370 & X-371 via the same base-station, using two accounts configured in the Yealink device...
  2. aaronphone

    Cisco SPA8000 IAD connected to a NEC SV9100

    Hi Guys, Just to let you know that i changed/enabled the CPC settings on the Cisco SPA8000 and the disconnect works perfectly, you need to reboot the device once CPC changes are made...as a matter of fact, the telco is now changing the firmware of the SPA8000 units, so that all new roll outs...
  3. aaronphone

    Cisco SPA8000 IAD connected to a NEC SV9100

    Cheers for your reply OzzieGeorge, I'm going to head to site next Wednesday, nearly 3 hours drive one way, to give these settings a go. I will post the outcome...
  4. aaronphone

    Cisco SPA8000 IAD connected to a NEC SV9100

    Hi, I have recently installed a new NEC SV9100 that has using a SIP to ATA appliance (Cisco/Linksys SPA8000), the customer is using all 8 lines of this product via the GCD-4COTC + GPZ-4COTC. We have discovered that all 8 line are not sending disconnect tones with the outside caller hangs up...
See more

Part and Inventory Search

Back
Top