Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

911/999 Notification

AVAYA: IPO Office FAQ

911/999 Notification

by  TaureanDragon  Posted    (Edited  )
The approach allows 911 calls to be made, even if the VmPro is not running, but if running makes use of the fact that a call to 911 will invoke a call record request that can be manipulated to provide a notification of the event.

Note: The VmPro only gets invoked when a connected event is returned from the network. If a caller dials 911 and hangs up before a connection is established, this will not generate an event.

Using the IP-Office Manager
To ensure calls made to a specific number
(in our case 911) are automatically recorded.
Setup an Account Code Where:
On the Account Code Tab:
- The Account Code Field should contain
a Reference Number (Lets say 911)
- The CLI field contains the dialled
number upon which the account code is
to trigger. (This for our cause needs
to be 911).

On the Voice Recording Tab:
- The 'Record Outbound' Field should be
set to 'ON'
- Set the 'Auto Recording Mailbox' to say
'2666 Joe Bloggs'

Now, whenever an extension dials 911 the switch will request the call is recorded, and the recording is delivered to 'Joe Blogg's Voicemail. 'Joe Bloggs' Could be a distribution list, with members setup for voicemail to email.

If the notification after the event is too late, or the fact you can't workout which extension made the call is an issue, then more config will need to be done on the Voicemail Pro.

Using the VmPro Client
Create a module called AutoRecord
Connect the Start to a 'Test Variable' Action.
On the Specific Tab
- Enter the variable name '$TARGET'
- Check the 'Specific' Checkbox and
enter '2666' in the field to its right

The Test variable will have two, maybe three
exits. (The Timeout one is an error I think)
Connect the 'No Match' and 'Timeout' connections
to a Listen Action
On the Specific Tab
Check the 'Mailbox' checkbox and fill in
the field with '$UUI'.
As long as the Auto Record request was not
targeted for '2666', the AutoRecord will
record the call to the target selected in the
IP Office Manager.

If the AutoRecord Request is targeted for '2666'
the callflow will exit via the 'Test Variable'
action 'Specific' exit.
$CLI - Contains Callers Extn No.
$DDI - The Number Dialled
$TARGET - Mailbox targeted for the recording.

Should now have enough infromation to use the Callflow to deliver a solution.

(For notification when other numbers are dialed, simply replace the '911' with the number required).

Register to rate this FAQ  : BAD 1 2 3 4 5 6 7 8 9 10 GOOD
Please Note: 1 is Bad, 10 is Good :-)

Part and Inventory Search

Back
Top