Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Point to Point ISDN IP Office Config

AVAYA: IPO Office FAQ

Point to Point ISDN IP Office Config

by  MrIPO  Posted    (Edited  )
Below is how to config a Point to Point ISDN connection using PPP and IP using IP Office

SITE A
1. In the System configuration form, change the IP address of LAN1 to 192.168.42.1.
2. Save and send the configuration to the IP Office.
3. Release and renew the IP configuration on your PC.
4. Create a new Normal Service as follows:
A) Name = ACME
Account Name = California
Password = Bells
Confirm Password = Bells
Telephone = phone number at Site B
B) Create a new IP route as follows:
IP address = 192.168.45.0
IP mask = 255.255.255.0
Destination = Georgia
C) Check the following default Incoming call route is
configured correctly:
Incoming number = blank
Incoming bearer = Any Data
Destination = DialIn
D) Check the following default RAS service is
configured correctly:
Name = DialIn
E) Create a new User as follows:
Name = ACME
Password = Benskins
Confirm Password = Benskins
Dial In On = Ticked
5. This User will now be automatically linked to the Service called ACME, as they both have the same name (the User Password is now the Incoming

SITE B
1. Check the following default Incoming call route is configured correctly:
Incoming number = blank
Incoming bearer = Any Data
Destination = DialIn
2. Check the following default RAS service is configured correctly:
Name = DialIn
3. Create a new User as follows:
Name = California
Password = Bells
Confirm Password = Bells
Dial In On = Ticked
4. Create a new IP route as follows:
IP address = 192.168.42.0
IP mask = 255.255.255.0
Destination = California
5. Create a new Normal Service as follows:
Name = California
Account Name = ACME
Password = Benskins Confirm Password = Benskins
Telephone = phone number at Site A
6. This Service will now be automatically linked to the User called California as they both have the same name (The User password is now the Incoming Password).
7. Save and send the configuration to the IP Office.
Both Sites

1. When both sites are ready, test the connection by pinging one another (If you are at Site A, ping B. If you are at Site B, ping A.).
Register to rate this FAQ  : BAD 1 2 3 4 5 6 7 8 9 10 GOOD
Please Note: 1 is Bad, 10 is Good :-)

Part and Inventory Search

Back
Top